Problem in addition of IP address to vrrp interface

[Gauri Senad]

Hello,

I am using 6WIND stack for addition vrrp-interface. When I add first vrrp
in the system using 6wing CLI its is getting added successfully. Now when
the second vrrp interface is added its IP address is not getting attached
to the vrrp interface. Following is the "ifconfig" output. Any one has seen
such issues earlier with 6wind stack?

ifconfig | grep -A 5 vrrp
vrrpv2g5 Link encap:Ethernet HWaddr 00:00:5E:00:01:05
inet addr:10.112.107.99 Bcast:10.112.107.103
Mask:255.255.255.248
inet6 addr: fe80::200:5eff:fe00:105/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:964 errors:0 dropped:0 overruns:0 frame:0
TX packets:224 errors:1 dropped:0 overruns:0 carrier:0
--
vrrpv2g6 Link encap:Ethernet HWaddr 00:00:5E:00:01:06
inet6 addr: fe80::200:5eff:fe00:106/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
-------------------> There is no IP address on this VRRP. Ideally there
should be 10.112.107.107/29 on it.
RX packets:40 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:2 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000


Regards,

Gauri